Vatech Smart Plus PHT-35LHS - Before You Begin; Conventions in This Manual

Table of Contents
iii Smart Plus (PHT-35LHS) Installation Manual
Table of Contents
Notice .............................................................................................................................. i
Important Notes ............................................................................................................. ii
Table of Contents ......................................................................................................... iii
1. Introduction .................................................................................................... 1
1.1 Manufacturer's Liability ........................................................................ 1
1.2 Customer’s Responsibility .................................................................... 1
1.3 Conventions in this Manual .................................................................. 2
1.4 Marks and Symbols ............................................................................. 8
1.5 Standards and Regulations ................................................................ 10
2. Choosing an Installation Site ...................................................................... 11
2.1 Room Requirements .......................................................................... 11
2.2 Specifications for Electrical Installation............................................... 15
2.3 Electrical Requirement ....................................................................... 15
2.4 Environmental Specifications ............................................................. 17
2.5 Exposure Switch Installation Options ................................................. 18
2.6 Installation Versions ........................................................................... 20
2.7 Installing the Warning Lamp and Door Interlock Switch ...................... 21
2.8 Installing the Emergency Stop Switch ................................................ 21
3. Before Installing the System ....................................................................... 22
3.1 Required Tools ................................................................................... 22
3.2 Checking the ShockWatch and TiltWatch Indicators ........................... 24
3.3 Unpacking Boxes ............................................................................... 25
3.4 Checking the Parts ............................................................................. 33
4. Installing the Equipment: Base Stand (Optional)....................................... 40
4.1 Assembling the Base and Main Units ................................................. 40
4.2 Installing the CEPH Unit (Optional) .................................................... 44
4.3 Installing the Wall and Column Brackets ............................................ 48
4.4 Fixing the Base (Optional) .................................................................. 54
4.5 Connecting the Cables to the Equipment. .......................................... 57
4.6 Removing the Transportation Safety Bolts ......................................... 59
4.7 Leveling the Equipment...................................................................... 61
4.8 Tightening the Bolts ........................................................................... 63
5. Installing the Equipment: Wall Mount ......................................................... 64
5.1 Installing the Equipmet ....................................................................... 64
5.2 Installing the CEPH Unit (Optional) .................................................... 69
5.3 Installing the Wall and Column Brackets ............................................ 69
5.4 Removing the Transportation Safety Bolts ......................................... 75