7. Setting up PC
88 Smart Plus (PHT-35LHS) Installation Manual
Installing selectable Frame Grabber Board
1. Unplug the power cable from the back of the PC and wait for a while.
2. Open the PC cover.
3. Insert the frame grabber (Part No. 21) carefully into that PCIe2 x 4 slot and
lock it.
<IFG Card> or <FTG Card> or <LEG Board>
Double-check the locking status between the board and its
holder after the board is installed. A bad insertion of the board
into the PC slot could cause failure for Dark calibration data
acquisition or noisy image acquisition.
4. Put the slot holder back to its initial position.
To Next Page
Loading...
