Vectrix VX-2 2011 - Page 19

VECTRIX VX-2 SERVICE MANUAL
The four Phillips screws for the top are plate screw 3.5 x
12mm
The four Phillips screws for the side are plate screw 3.2 x
12mm (black)
Assemble all parts in the other direction
Put in the screws slightly and if all screws and the cover are in the correct positions tighten
them.
Rear Side Panel Emblem/Nameplate Replacement
S-XC-S00329
Removal Procedure
1. Right side:
Remove the right rear & cheek panel. Refer to Rear & Cheek Panel Right Replacement in Body
Rear End.
Left side:
Remove the left rear & cheek panel. Refer to Rear Cheek Panel Left Replacement in Body Rear
End.
2. Remove the 2 screws (1) and remove the Emblem/Nameplate.
Version 1.0/May 2011
VECTRIX, LLC