Vectrix VX-2 2011 - Sevcon Motor Controller

VECTRIX VX-2 SERVICE MANUAL
SECTION C-14:
SEVCON MOTOR CONTROLLER
Preparations:
Disassemble Seat see Section B-8
Disassemble Left and Right Rear Body Panels see Section B-10
Open the seat and remove Cover of electronic box by
using
- Phillips screwdriver (old version)
- Special secure Torx screwdriver (new version)
Turn Key Switch in “ON” Position
Unplug blue Battery Main Connector
Turn Key Switch in “OFF” Position
Disconnect Positive Terminals first and remove Main Fuse
(1)
Then disconnect remaining (Negative) cables and wiring
harness
1
Version 1.0/May 2011
VECTRIX, LLC