Vectrix VX-2 2011 - Motor

VECTRIX VX-2 SERVICE MANUAL
SECTION C-15:
MOTOR
Preparations:
Disassemble Side Cover see Section B-15
Disassemble Rear Brake see Section B-16
Note
: This is the same procedure to replace the Rear Brake Rotor
Open the seat and remove Cover of electronic box by
using
- Phillips screwdriver (old version)
- Special secure Torx screwdriver (new version)
Turn Key Switch in “ON” Position
Unplug blue Battery Main Connector
Turn Key Switch in “OFF” Position
Disconnect Positive Terminals first and remove Main Fuse
(1)
Disconnect Remaining (Negative) Cables and Wiring
Harness
1
Version 1.0/May 2011
VECTRIX, LLC