VECTRIX VX-2 SERVICE MANUAL
SECTION C-2:
THROTTLE
Preparations:
Disassemble Front Fairing see Section B-1
Disassemble Front Vertical Panel-Lower see Section B-4
Disassemble Front Vertical Panel-Upper see Section B-5
Disassemble Front Console Cover see Section B-2
Lower Regen Throttle Box Replacement
S-XC-S00077
Tools Required:
PH #2
8mm Turned Full-contact Hexagonal Socket (S02445)
Removal Procedure
1. Turn ignition key to the off position.
2. Remove three screws (3,4) from the lower throttle box assembly.
3. Lift the kill switch housing (1) up and away from lower box.
4. Using 8mm Hexagonal Socket S02445 remove two lower box U-Bolt nuts (5).
Note the orientation of the throttle return spacers and spring for reassembly.
5. Remove the U-Bolt (6). Pull down on the lower box (2) and remove.
6. Slide the throttle assembly off of the handlebar.
Version 1.0/May 2011
VECTRIX, LLC
To Next Page
Loading...
