VECTRIX VX-2 SERVICE MANUAL
SECTION C-11:
REAR TAIL LIGHT ASSEMBLY
Preparations:
Disassemble Left and Right Rear Body Panels see Section B-10
Remove all cable strips
Open 3-pin connector
Unscrew the two side screws and one middle screw with
Phillips screwdriver
Pull out the Tail Light assembly backwards and disconnect
plug.
Replace entire Tail Light Assembly
Note
: Since the Rear Tail Light is LED, you must replace
the whole assembly.
Assemble all parts in the other direction
Test function of Brake and
Position lights
Version 1.0/May 2011
VECTRIX, LLC
To Next Page
Loading...
