VERITAS NetBackup 5230 Hardware Installation Guide

This list describes the components of the drawing.
DescriptionNumber
Captive screw that connects the appliance to the rack.1
Blue peg that connects the rail bottom to the rack.2
Empty (no screws or pegs).3
Silver peg that connects the rail top to the rack.4
The silver peg is on the top of each rail. The blue peg is on the bottom of each rail.
The blue peg and the square silver peg snap into the rack without screws or cage
nuts.
To install the rack rails
1
Identify the one RU on each side of the rack where you plan to install the rails.
2
Verify that there is one complete RU available under the RU used for rail
installation.
24Installing hardware into racks
Installing the appliance guide rails

VERITAS NetBackup 5230 Specifications

General

Language version	-
License type	Corporate
License quantity	- license(s)
License term in years	1 year(s)