VERITAS NetBackup 5230 Hardware Installation Guide

■ Lift the cover off the chassis and set it aside where it cannot be damaged.
Installing the additional memory
Base NetBackup 5230 appliances are equipped with 64GB of memory. When a
base unit is upgraded to use storage shelves, 64GB of additional memory must be
installed. Memory is included in the upgrade kit. Additional components are not
required to install additional storage shelves.
To install the memory
1
Remove the air duct as follows:
Note: The air duct is the plexiglass cover behind the fan bulkhead as shown
in the following figure. The air duct has two blue latches attached.
■ Locate the two, blue latches (A) that secure the back end of the air duct to
the chassis. Push the latches in to release the air duct.
87Adding 2U12 storage shelves to an operational NetBackup 5230 Appliance
Installing the additional memory

VERITAS NetBackup 5230 Specifications

General

Language version	-
License type	Corporate
License quantity	- license(s)
License term in years	1 year(s)