Note: When the 3U16 storage shelf starts, the primary I/O module (on the left
side of the rear panel) starts first. Its LED turns green a few seconds after the
start. The LED of the secondary I/O module (on the right of the rear panel)
starts after the primary module is operational.
8
Repeat this procedure for all storage shelves.
See “Turning on the appliance ” on page 40.
Turning on the appliance
All devices must be correctly installed and all cables must be connected properly.
When turning on the hardware, do not remove or handle any disks, optical fibers,
or network cables. Otherwise, data may be lost and equipment may be damaged.
To turn on the appliance
1
Connect both AC power connectors on the rear panel of the appliance to two
main AC power supply outlets.
2
Attach a monitor to the VGA plug, and a keyboard to one of the USB ports. If
a KVM switch is available, attach both the monitor and keyboard to the switch,
and plug the switch into the VGA.
3
Verify that each storage shelf has been turned on and is running properly.
4
Turn on the appliance, using the power button which is located on the right
side of the front panel.
5
Determine if the appliance is running properly.
■ Check the Status LED (1), and Activity (2) LED on the installed disk drives
on the front panel.
40Verifying hardware operation and configuring IPMI
Turning on the appliance
To Next Page
Loading...
Need help?
General
