VERITAS NetBackup 5230 Hardware Installation Guide

Verifying hardware
operation and configuring
IPMI
This chapter includes the following topics:
■ Hardware verification
■ Turning on the storage shelves
■ Turning on the appliance
■ Configuring the IPMI from the NetBackup Appliance Shell Menu
■ Accessing and using the Veritas Remote Management interface
Hardware verification
Check the information in Table 5-1 after the hardware installation and cable
connections are complete, but before the devices are turned on.
Note: Do not attach external devices, such as tape drives or SAN clients, to the
appliance until this process has been completed.
Warning: Confirm that all power to the devices is turned off to prevent personnel
injuries and to prevent damage to the devices.
Verify that the devices and cables are installed correctly. The following table provides
instructions for checking the device installation.
5
Chapter

VERITAS NetBackup 5230 Specifications

General

Language version	-
License type	Corporate
License quantity	- license(s)
License term in years	1 year(s)