Configuration Parameters D-15
Appendix D: Using the Configuration File
Edge 5000 Installation / Configuration Guide
FWRD noanswer_time Sets the no-answer time, in seconds, for no-answer forward.
Valid values are 1 to 30.
The default is 10.
DIAL dial_mode Sets the default dial mode.
Valid values are number (digits), IP address or URL.
The default is number.
pause_timer Specifies the pause timer, in seconds, for the dial plan.
Valid values are 1 to 30.
The default is 3.
inter_digit_timer Sets the time delay before dialed digits are sent for normal
dialing, in seconds.
Valid values are 1 to 30.
The default is 6.
dialplan Specifies the dial plan type.
Valid values are digitmap or routing.
The default is routing.
digitmap Defines a digit map string for the dial plan,
The valid value is a maximum 512-character string.
Default is “x.T|x+#”.
digitmap_tone Defines the digit map string to deliver second dial tone for a dial
plan.
The valid value is a maximum 512-character string.
Default is blank.
digitmap_emergency Defines the emergency call number.
Valid value is a string up to 750 characters.
The default is blank.
digitmap_process Defines the digit map process for a dial plan.
Valid values are:
• num: the digitmap string, maximum 512-characters.
• trunc: number of digits to strip, 0 to 30.
• prefix: digits to insert in front of the number, maximum 32
digits.
• post: digits to insert at the end of the number, maximum 32
digits.
The default is blank.
Section Field Name Description
To Next Page
Loading...
