Configuration Parameters D-20
Appendix D: Using the Configuration File
Edge 5000 Installation / Configuration Guide
PROVISION https_id Specifies the ID for authenticating to an HTTPS session.
The valid value is under 50 characters.
The default is blank.
https_password Specifies the password for authenticating to an HTTPS session.
The valid value is under 50 characters.
The default is blank.
https_macform Specifies the filename of phone specific configuration file. The
name or path must include “$MAC”, which is replaced by the
MAC address during provisioning.
The valid value is a maximum of 50 characters and includes
“$MAC”.
The default is “$MAC”.
verifying_cert Defines a hexadecimal value composed of a 3-bit field flag for
HTTPS certification verification. 0x01 checks valid certification
authority. 0x02 checks whether a server name is valid. 0x04
checks whether a certification is expired.
Valid values are 0 to 7.
Default is 7
smartup_use Enables Smart Update, to check for and download firmware
periodically.
Valid values are enable or disable.
Default is enable.
smartup_type Defines the timing of Smart Upgrade as an interval or time of day.
Valid values are 1 for interval or 2 for daily
Default is 2.
smartup_interval Specifies the interval, in seconds, between firmware checks.
Valid values are 0 to 86400 seconds.
Default is 3600.
smartup_time Specifies the time of the day for daily firmware checks.
Valid values are 0 to 23 o’clock.
Default is 00:00.
smartup_confirm Enables user confirmation of firmware download from the
provisioning server.
Valid values are enable or disable.
Default is enable.
Section Field Name Description
To Next Page
Loading...
