SIP Configuration, Line Parameters 3-15
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
• Input the Call Server Address or FQDN using the dial pad and press the [OK] softkey
to save your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Call Server Address requires a reboot of the IP Phone; when you leave the menu,
you will receive a reboot notice. The IP Phone must reboot to utilize the new values enteredTo
enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E for the character
mapping of dial pad digits.
Proxy Port
The Proxy Port defines the TCP/UDP port number employed for SIP signaling transport. In
common practice, port number '5060' is used.
To change the Proxy Port number:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 1.Line Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Enter the line button number or move the cursor using the [Next]-[Previous] softkeys
and press the [OK] softkey to select a line button.
• Press the digit, or move the cursor to 2.Proxy Port using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Input the Proxy Port number using the dial pad and press the [OK] softkey to save
your entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: Changing the Proxy Port requires a reboot of the IP Phone; when you leave the menu, you will
receive a reboot notice. The IP Phone must reboot to utilize the new values entered.
To Next Page
Loading...
