Vertical Edge 5000 - Page 38

SIP Configuration, Line Parameters 3-16
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
Display Name
When assigned, the Display Name is used in SIP headers as the caller id name.
To enter the Display Name:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 1.Line Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Enter the line button number or move the cursor using the [Next]-[Previous] softkeys
and press the [OK] softkey to select a line button.
• Press the digit, or move the cursor to 3.Display Name using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Input the Display Name using the dial pad and press the [OK] softkey to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings ( ) button to exit the configuration session.
NOTE: To enter alphanumeric characters select the [Mode] softkey. Refer to Appendix E for the
character mapping of dial pad digits.
Name
The Name is used in SIP headers as the SIP user id or account assigned in the call server. A
name is required for proper operation and must match the user id or account assigned in the
call server.
To enter the Name:
• Press the Settings ( ) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4.
• Press the digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 1.Line Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Enter the line button number or move the cursor using the [Next]-[Previous] softkeys
and press the [OK] softkey to select a line button.
• Press the digit, or move the cursor to 4.Name using the [Next]-[Previous] softkeys
and press the [OK] softkey.
Release 1.0
September 2010