Need help?Do you have a question about the Vertiv EXS and is the answer not in the manual?
General| Efficiency | Up to 96% |
|---|---|
| Frequency | 50/60 Hz |
| Operating Temperature | 0-40°C |
| Humidity | 0-95% non-condensing |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Battery Type | VRLA |
| Form Factor | Tower |
| Communication Ports | USB |
| Topology | Double Conversion Online |
| Output Voltage | 220/230/240 VAC |
Information on connecting multiple UPS modules for increased capacity and reliability.
Crucial functions for battery health, including charging and protection.
Covers automatic charging, temperature compensation, EOD, pre-warning, and discharge protection.
Environmental, mechanical requirements, and safety warnings for installation.
Guidelines for selecting and connecting UPS input, bypass, output, and battery cables.
Instructions for protective earth connection and external protective devices.
Overview of configurations and steps for connecting the system input.
Connecting input and output cables for different configurations.
Procedures for connecting batteries and an overview of signal cable ports.
Setting battery parameters and output voltage, frequency, and phase during initial setup.
Explanation of UPS prompts and a comprehensive list of alarm messages.
Important safety warnings and precautions before and during UPS operation.
Essential checks to perform and the initial interface displayed when starting the UPS.
Step-by-step guide for starting the UPS in normal operating mode.
Steps for starting the UPS in battery mode (cold start), especially with internal batteries.
Procedures for transferring UPS between Normal, Battery, and Bypass modes.
Steps for completely powering off the UPS and explanation of the REPO function.
Critical safety warnings and precautions for working with high-voltage UPS batteries.
Correct procedures for tightening battery terminals and inspecting/handling batteries.
Information on valve-regulated batteries, parallel strings, and optimal storage conditions.
Important considerations for designing battery installations and environment requirements.
Requirements for battery count, protection, and installation steps.
Regular maintenance checks and procedures for disconnecting internal batteries.
Procedures for installing parallel UPS systems, including preliminary checks and cabinet placement.
Guidelines for power cable wiring and parallel cable connections.
Notes on parallel cables and procedures for starting up a parallel UPS system.
Steps to isolate and reintegrate UPS modules from/to a parallel system for maintenance.
Connecting LBS cables and setting LBS parameters (Disable, Slave, Master).
Introduction to internal battery kits and their parameters.
Detailed procedures and precautions for maintaining UPS batteries for optimal performance.
To Next Page