DSP FW version
Version of DSP firmware on the UPS power module.
MAC address
Shows the MAC address of the RDU101 card. This is only shown when the RDU101 card is installed.
IPv4 address
Shows the IPv4 address of the RDU101 card. This is only shown when the RDU101 card is installed.
Subnet mask
Shows the subnet mask of the RDU101 card. This is only shown when the RDU101 card is installed.
Gateway address
Shows the gateway address of the RDU101 card. This is only shown when the RDU101 card is installed.
Efficiency Tab
Capacity
This shows the maximum capacity of your UPS model.
Cap. (%)
This shows the percentage of the maximum capacity your UPS is currently using.
Eff. (%)
This shows the efficiency the UPS is currently operating at based on the Cap. (%) value.
Battery Age
This page also displays the following values:
Battery recommended replacement date
This shows the date that it is recommend to replace the battery. It is 5 years from the time the battery was
installed.
SOH (%)
This shows the current SOH percentage.
5.3 Editing Display and Operation Settings
You may adjust the display settings and UPS configuration via the LCD. The display and operation settings are password
protected. The default password is 111111 (six ones).
NOTE: We recommend that you change the password to protect your system and equipment and record the new
password and store it in an accessible location for later retrieval. See Changing the Password on the facing page.
To enter the password:
1. Press the up-arrow button to change the digit shown, then press the down-arrow button to move to the next
digit.
2. Repeat to select each digit, and press Enter to submit the password.
54 Proprietary and Confidential ©2024 Vertiv Group Corp. 5 Operation and Display Panel
Vertiv™ Liebert® GXT5 UPS Installer/User Guide
To Next Page
Loading...
Need help?
General
