MECHANICAL INSTALLATION Liebert Trinergy™ Cube
Installation Manual - 10H52243IM60 - rev. 7 - 06/2020 Page 9
Keep all protective shrink wrap on the unit and remove only when required. If the units does not have
an external temporary protection installed on the top of the unit (see image below), contact Vertiv
technical support. The UPS is shipped with external protection material that must remain attached to
the UPS to protect potential areas of foreign debris ingress to the UPS. In addition to the external
protection material, filters installed on the top and front of the UPS must not be removed during
construction activities. All filter media is necessary to prevent debris or dust entry to the UPS throughout
the installation process. The external temporary protection at the top of the UPS will be removed by a
Vertiv Customer Engineer during startup and must be reinstalled when the UPS is not operating during
construction activities.
Do not remove the protection fixed to the roof;
it must be removed only before the start up
To Next Page
Loading...
Need help?
General