Introduction Liebert Trinergy™ Cube
Installation Manual - 10H52243IM60 - rev. 7 - 06/2020 Page 5
1. INTRODUCTION
This manual contains information about installing the Liebert Trinergy
TM
Cube, Uninterruptible Power
System (UPS) and the batteries.
This equipment must be installed and operated by qualified personnel, who are advised to read this
manual before starting.
Afterwards, the manual must be kept and referred to whenever work must be done on the UPS.
1.1. Notes to the CE Declaration of Conformity
Liebert Trinergy
TM
Cube conforms to the following European directives:
2014/35/EU
Directive of the council for adapting the legal regulations of member states on electrical equipment for
use within specific voltage limits (superseding 2006/95/EC and successive amendments).
2014/30/EU
Directive of the council for adapting the legal regulations of member states on electromagnetic
compatibility, (superseding 2004/108/EC and successive amendments).
Conformity is established through compliance with the following standards:
• IEC/EN 62040-1 + 1A: 2013
• IEC/EN 62040-2: 2006
Additional information regarding adherence to these directives is included in appendices NSR and EMC
to the Declaration of Conformity. If needed, the Declaration of Conformity can be requested from Vertiv.
2011/65/EU
Directive of the council for adapting the legal regulations of member states on the restriction of the use
of certain hazardous substances that can be used in the manufacture of electrical and electronic
equipment.
1.2. Symbols and pictograms
The following symbols and pictograms are used in this handbook:
1.3. Documentation structure
These instructions may be supplemented with additional sheets describing specific extensions or
options.
Warning
Indicates instructions which, if not followed, may result in danger to life, safety, the reliability of
your device or data security.
Notice
Indicates additional information and tips.
Indicates a step that you must carry out.
To Next Page
Loading...
Need help?
General