MAP-200 Optical Switch mOSW-C1 Installation and User Guide Page 24
June 2016 Document Number: 22112369-120 R000 Status: Standard
Chapter 5: Getting Started
Required Software
The mOSW-C1 requires MAP-200 software version 2.8.x or higher on the chassis.
Before Initializing and Operating the Unit
Wear an anti-static wrist strap, and work in an electrostatic discharge (ESD)
controlled area.
Inspect the unit for any signs of damage.
If the contents are incomplete or damaged, immediately inform Viavi and, if
necessary, return the unit as outlined in the Service chapter.
Keep the packaging.
Read the user’s manual thoroughly, and become familiar with all safety symbols
and instructions to ensure that the unit is operated and maintained safely.
Initial Inspection
WARNING
To avoid electrical shock, do not initialize or operate the unit if it bears
any sign of damage to any portion of its exterior surface such as the
outer cover or panels.
Check that the unit and contents are complete:
1. Inspect the shipping container for any indication of excessive shock to the
contents, and inspect the contents to ensure that the shipment is complete.
2. Inspect the unit for structural damage that can have occurred during shipping.
3. Keep the packaging.
To Next Page
Loading...