MAP-200 Optical Switch mOSW-C1 Installation and User Guide Page 99
June 2016 Document Number: 22112369-120 R000 Status: Standard
Chapter 11: Service
Storing and Shipping
To maintain optimum operating reliability, do not store the unit in locations where the
temperature falls below -30 °C or rises above 60 °C. Avoid any environmental
condition that can result in internal condensation. Ensure that these temperature and
humidity requirements can also be met whenever the unit is shipped.
Claims and Repackaging
Immediately inform Viavi and, if necessary, the carrier, if
• The contents of the shipment are incomplete
• The unit or any of its components are damaged or defective
• The unit does not pass the initial inspection
In the event of carrier responsibility, Viavi will allow for the repair or replacement of
the unit while a claim against the carrier is being processed.
Packing Guidelines With Original Packaging
• Ensure foam is properly placed
• Use the L-Shaped cardboard piece to hold controller in place
• Do not ship with the display mounted on the chassis, ensure it is packaged
separately
• Do not ship with MTLS and MTBF populated in the chassis
Packing Guidelines Without Original Packaging
• Do not ship with any modules populated in the chassis
• Do not ship with the display mounted on the chassis, ensure it is packaged
separately
• Ensure the bottom of the chassis is supported
• Ensure sufficient cushioning is provided for all modules, chassis and display
being shipped
To Next Page
Loading...