Instruments and controls
48
Instrument panel
2 Engine coolant temperature gauge
The gauge shows the temperature of the engine coolant. The
more black bars, the higher is the temperature. If the temperature
becomes abnormally high, the warning lamp will light up and the
buzzer will sound.
If this happens, stop work immediately and investigate the
cause.
3 Fuel level gauge
The gauge shows the level in the fuel tank. When the tank is full,
all bars are black. When only one section remains, it starts to flash.
Refuel the machine immediately in order to avoid air entering the
system. Always refill the fuel tank at the end of every work day.
If the tank has been run empty, see
Bleeding fuel system of air
on page 169. For the capacity of the fuel tank, see
Capacities,
Intervals between changes/replacements
on page 213.
4 Parking brake indicator (not applicable)
The lamp is alight when the parking brake is applied. Release the
parking brake by selecting T-, W-mode with the mode selector. The
parking brake can also be released by putting the control lockout
lever in the upper position.
(®)
S86019
5 Brake oil pressure warning indicator (not appli-
cable)
The lamp is alight, the central warning lamp blinks and the buzzer
sounds when the brake pressure is too low or if one brake circuit
does not work.
6 Low steering pressure indicator (not applica-
ble)
The lamp is alight, the central warning lamp blinks and the buzzer
begins to sound if a fault arises in the primary steering system.
WARNING!
The machine must not be operated until the fault has been
rectified and the control lamp has extinguished.
$86020
S86021
To Next Page
Loading...
