Note!
Do not use terrain-TCS during
normal driving.
Switching off the TCS
When testing on a roller bench or when towing with an
axle raised, the TCS must be switched off.
Use the display to switch off the TCS. The vehicle
must be stationary.
1 Step to the “Settings” menu (3 and 4)
2 Press “Select” (2)
3 Step to the “Traction Control” menu (3 and 4)
4 Press “Select” (2)
5 Step to the “Off” menu (3 and 4)
6 Press “Select” (2)
The next time the starter key is turned to the driving
position or the front axle is rotating faster than
12 km/h
the TCS is engaged again.
J3008810
Note!
Switch off the TCS before towing
with any axle raised!
Note!
Switching off the TCS in the display
disables the TCS switch.
If TCS is activated after a wheel change
If you fit smaller wheels on the drive axle than what
was fitted previously, the
TCS
may be activated.
Drive a distance at above
25 km/h
. The
EBS
system
then learns the difference between the wheel sizes.
How far you need to drive depends on how big the
difference in sizes is between the wheels.
It may be difficult to drive due to the
TCS
limiting the
engine torque. In this case, engage the terrain-
TCS
.
134
Driving
To Next Page
Loading...
