2 Move the cursor to "Programming" using ▲ and
▼.
3 Confirm with "SELECT".
4 Set the start date with ▲ and ▼
Current date is default.
5 Confirm with "SELECT".
6 Set the start time with ▲ and ▼
7 Confirm with "SELECT".
8 Set duration with ▲ and ▼
The time is changed in 10 minute intervals. The
longest time that can be set is 2 hours.
9 Confirm with "SELECT".
10 The set time and date are shown.
11 Confirm with "SELECT".
Reset, p-heater timer
1 Press "SELECT".
2 Move the cursor to "Reset" using ▲ and ▼.
3 Confirm with "SELECT".
Language
1 To set the required language press "SELECT".
2 The display now shows up to three different
languages. Select the desired language by moving the
cursor to the row concerned with ▲ and ▼. Confirm
the choice with "SELECT".
Units
Distance
Select if the trip should be shown as km or miles.
1 Mark the desired unit with ▲ and ▼.
2 Confirm with "SELECT".
3 "Esc" aborts the setting.
Information display
61
To Next Page
Loading...
