Main fuses
The main fuses are located in the main fuse box inside
the battery box on the chassis. The four fuses are
screwed into the fuse box with spring washers and
nuts. It is important that the nuts are tightened to the
correct torque, see table. If they are not tightened
enough, heat can be generated. Too high torque can
cause deformation and cracks.
Warning!
Use the correct tightening torque.
Do not forget the spring washers.
J3014566
Dimensions Tightening torques
M5 4.0 Nm +/- 5%
M8 20.0 Nm +/- 5%
M10 33.0 Nm +/- 5%
Normally the fuses last as long as the truck without
blowing. Should a fuse blow, the truck should be taken
in to the workshop for a check of the electrical system.
Size Use
1 125 A Preheating
620
Fuses and relays
To Next Page
