In this menu the carrier can enter the fleet ID of the
truck if required. Data registered in the engine control
unit is then registered for that ID.
1 Set new Fleet ID
Set the first digit or letter with ▲ and ▼
Step to the next digit using "SELECT"
Step backwards with ”Esc”
13 digits must be entered (a space is entered for
unused positions).
2 Confirm the new Fleet ID with "SELECT"
3 The message "Transfer complete" is shown
If the setting fails:
• Press "Esc" and try to do the setting one more time,
see point 1.
• If it still will not work, perform diagnostics of the
display and engine control unit, see section “Fault
diagnosis”.
• Contact a workshop if necessary.
Trailer detection
Trailer detection can be shut off in this menu. A reason
for deactivating trailer detection could be to avoid
flashing lamps when using a trailer with LED rear
lights. LCM can currently not detect the low current
consumption of this type of lamp, so we recommend
the use of normal filament lamps.
1 Select “On” or “Off” with ▲ and ▼.
2 Confirm with “SELECT”.
3 “ESC” aborts the setting.
If trailer detection is “Off”, the driver should observe
the following:
• Trailer indicator in the display is not active
(warning lamp).
•
I-shift
can select incorrect starting gear, which can
result in an overloaded clutch. When coupling a
Note!
A truck with inactivated trailer
detection does NOT fulfil the legal
requirements for fault indication of
direction indicators on a trailer
(according to ECE R48 6.5.8
warning lamp). Functioning lamps
for direction indication on a trailer
are obligatory.
Note!
Remember to reset the trailer
detection to “On”. This is done in
the same way as turning it off.
Information display
67
To Next Page
Loading...
