Information messages
When this light comes on a new information message
is displayed. The lamp is used for information. The
lamp being lit does not mean that there is a fault in the
vehicle.
Acknowledge the message with “Esc”. If the message
is still valid, it will be shown again the next time the
key is turned to the starting position. Previously
displayed messages can also be seen at “Vehicle
messages”.
If a message appears on the display and is
acknowledged, it can appear on the display again if the
reason for the message disappears after
acknowledgement but then reappears.
Example: If the gearbox oil temperature becomes too
high, a message is activated automatically. The driver
acknowledges this message using “Esc”. If the
temperature then drops to a normal level but then
becomes too high again, the message will be shown
again.
J3014366
Warning messages
Acknowledge the message with ”Esc”. If the fault is
still active, it will be shown again next time the starter
key is turned to the starting position. Previously
displayed messages can also be seen at “Vehicle
messages”. If a fault message appears on the display
and is acknowledged, it can appear on the display
again if the fault disappears after acknowledgement
but then reappears again.
Note!
This lamp lights when something
must be rectified. If it is a fault on
the truck, the truck shall be driven to
a workshop for repair. The truck will
not be damaged immediately and can
in certain circumstances complete
it's assignment first. It may also be
something that the driver can correct
himself, such as high temperature in
the transmission, by driving more
sedately or stopping the truck for a
while.
Information display
35
To Next Page
Loading...
