Hydraulic bogie lift
Lifting the bogie axle
1 Depress the upper part of the switch. A signal is
sounded indicating that the bogie lifting motor is
functioning.
2 Wait until the control lamp lights up. The bogie
axle is now completely lifted.
3 Put the switch in the middle position.
The indicator lamp in the switch only shows that the
switch is switched on.
Lowering the bogie axle
1 Depress the lower part of the switch. A signal is
sounded indicating that the bogie lifting motor is
functioning.
2 Wait until the control lamp lights up. The bogie
axle is now completely lowered.
3 Put the switch in the middle position.
The indicator lamp in the switch only shows that the
switch is switched on.
Avoid quick movements between the upper and lower
switch positions. Pass the middle position slowly, so
that the indicator lamp in the switch has time to go out,
otherwise there will be no change-over.
J0007833
Switch for bogie.
J3014468
Control lamp for bogie.
Note!
If the switch for the bogie is
depressed the bogie lift must be
allowed to become ready before the
switch is put in the middle position
again, otherwise the truck can suffer
damage.
Note!
Never use the bogie lift as long as
the control lamp for preheating is lit.
158
Driving
To Next Page
