• If it still will not work, perform diagnostics of the
display and engine control unit, see section “Fault
diagnosis”.
• Contact a workshop if necessary.
Fuel (target)
Only accessible if correct password is entered.
This function makes it possible for the carrier to set a
fuel consumption target. For information about fuel
consumption for a journey, see section “Trip data”.
1 Select Fuel (target) with ▲ and ▼.
2 Confirm with "SELECT".
3 State a new fuel target
Set the first digit with ▲ and ▼
Step to the next digit using "SELECT"
Step backwards with ”Esc”
4 Confirm the new fuel target with "SELECT"
5 The message "Transfer complete" is shown
If the setting fails:
• Press "Esc" and try to do the setting one more time,
see point 1.
• If it still will not work, perform diagnostics of the
display and engine control unit, see section “Fault
diagnosis”.
• Contact a workshop if necessary.
Ammeter sensor calibration
Ammeter sensor calibration must be performed when a
sensor or instrument is replaced.
Follow the instructions on the display. Cancel by
pressing ”Esc”.
Fleet ID
Only accessible if correct password is entered.
66
Information display
To Next Page
Loading...
