Scroll between values with ▲ and ▼. Return to
previous menu with "Esc".
If the transfer should fail, then "No data" is shown
when data is missing.
Reset trip data
Only accessible if correct password is entered.
Reset all information in menu "Trip data". Follow the
instructions on the display.
Password
Certain functions in the display are password
protected. There are three passwords for the display.
When the vehicle is supplied from the factory the
passwords are:
Workshop Password 1: 0000
Owner Password: 1234
Workshop Password 2: 5678
When “Workshop, password 1” is entered, it is
possible to reset values (applies to a number of
functions).
With the two other passwords the following menus can
also be accessed:
• Fleet limit: engine RPM
• Fleet limit: the speed
• Fleet limit: fuel
• Fleet ID
When the key has been in the stop position for more
than 60 seconds or the batteries have been
disconnected, the password must be entered again in
order to access all the functions.
It is possible to remove the password protection for
certain functions. This can be carried out by a Volvo
workshop.
1 Set the first digit with ▲ and ▼
2 Step to the next digit using “SELECT”
Note!
Change password to prevent
unauthorized access to menus, see
“Change Password”.
74
Information display
To Next Page
Loading...
