SHB 28Z3 EN – Edition 2.0 * 28z3s610.fm 6-9
Electrical system
6.15 Rotating beacon (option)
The rotating beacon is installed at the top rear of the cab.
6.16 Driving signal (option)
The driving signal is mounted at the rear right of the engine compartment.
The pressure switch for the driving signal is located directly on the underside of the drive
valve.
Driving signal wiring harness
Fig. 14: Rotating beacon
E
Pos. Description
E Rotating beacon
Fig. 16: Driving signal wiring harness
Plug Description
X1 Wiring harness connector
X2 S21 high-speed cable (not equipped)
X3 Pressure switch connector
X4 Driving signal connector
To Next Page
Loading...
