SHB 28Z3 EN – Edition 2.0 * 28z3s810.fm 8-17
PowerTilt PTS06
8.13 Trial assembly
Notice!
In some cases a so-called trial assembly may be helpful if the repair technician is
not familiar with the actual assembly, in order to find out how to align the teeth
correctly. As a rule, seals are not installed during a trial assembly. However, wear
indicators and pressure discs must be installed.
8.14 Installing the seals (kit A), shaft bearings and pressure discs (kit B)
Caution!
Bear the following in mind when installing the new components!
• Coat the seals and treated surfaces with high-quality hydraulic oil (in
accordance with DIN51524/T3 (HVLP)) before installation.
Notice!
The exact position and number of seals or bearings depends on the PowerTilt
model.
Fig. 32: Coat the seals and surfaces with oil
To Next Page
Loading...
