8-20 SHB 28Z3 EN – Edition 2.0 * 28z3s810.fm
PowerTilt PTS06
Fitting the shaft seal and the bearing
☞ Fit plug seal A8 on the shaft.
☞ Apply a little lithium grease to either side of pressure disc B5, and place the pressure
disc on shaft 2.
☞ Install the second pressure seal A9 with the lip showing inside.
☞ Install wear indicator B2.
Fig. 41: Plug seal of shaft
A8
Fig. 42: Applying grease to the pressure disc of the shaft
B5
Fig. 43: Fitting the pressure disc
B5
2
Fig. 44: Applying grease to the pressure disc of the shaft
A9
Fig. 45: Shaft wear indicators
B2
To Next Page
Loading...
