3-46 BA 50Z3/6003 en – Edition 4.3 * * 5003b330.fm
Operation
Longer/shorter lap belt adjustment:
• Hold buckle latch A at a right angle to the seat belt and pull the seat belt to the
required length.
• To shorten the lap belt, just pull the free end D of the belt.
3.27 Retracting lap belt (option)
Driving or working with the seat belt unbuckled is forbidden
Risk of injury.
☞ Always buckle up before moving or working with the machine.
• Do not fasten a twisted seat belt.
• Seat belt must run over the hips – not over the stomach – and must
always be applied tightly.
• Do not place the seat belt over hard, edged or fragile items (tools, metre
rule, glasses, pen) carried inside your clothes.
• Never buckle up 2 persons with one seat belt.
• Check the condition of the seat belt regularly. Have damaged seat belt
elements immediately replaced by a workshop.
• Always keep the seat belt clean, as coarse dirt can impair proper functioning.
• Seat belt buckle must not be obstructed by foreign bodies (paper or sim-
ilar); otherwise the buckle latch cannot lock into place.
After an accident the belt strap is stretched and no longer serviceable, even if
no optical defects can be detected.
In a further accident, the seat belt
Will not provide adequate protection.
☞ Replace the seat belt after every accident.
☞ Have fastening points and seat fixture checked for bearing capacity.
Seat belt S is for the user’s safety.
Fastening the seat belt:
☞ Fasten the seat belt as follows before starting the machine:
• Hold belt on buckle latch A and run it slowly and steadily over the hips to buckle B.
Fig. 105: Longer/shorter seat belt adjustment
A
D
S
Fig. 106: Unwinding the seat belt
A
To Next Page
Loading...
Need help?
General
