BA 50Z3/6003 en – Edition 4.3 * 5003b330.fm 3-21
Operation
3.11 Starting with the drive interlock – internal transponder (option) (from serial no. AJ02777)
A = operator’s key (blue key)
For starting the machine. Scope of delivery includes 2 keys.
B = master key (red key)
Store the master key in a safe place. It is only used for coding new keys.
All keys are deleted if the key remains in position 1 for more than 20 seconds.
The machine can be started without performing any further settings.
Coding a new key
• Insert master key B in the preheating start switch.
• Turn the key to position 1 for a maximum 5 seconds.
• Turn the key to position 0 and remove master key B.
• Now insert the new key or the key requiring coding in the preheating start switch and
turn it to position 1 within 15 seconds.
• This action registers the key.
The procedure is automatically cancelled if no key requiring coding is detected within 15
seconds. Several keys requiring coding can be inserted one after another in the preheating
start switch. Each key must then remain at least 1 second in position 1. Coding can be per-
formed for a maximum 10 keys.
Deleting coded keys
Deleting coded keys is necessary whenever a coded key is lost.
• Insert master key B in the preheating start switch.
• Leave the key in position 1 for a minimum 20 seconds.
• All coded keys are deleted after 20 seconds, and all existing keys can be re-coded.
The master key code is not deleted during deletion.
2 x 1 x
A
B
Fig. 57: Drive interlock key
1
0
2
3
Fig. 58: Position on preheating start switch
To Next Page
Loading...
Need help?
General
