WAGNER TwinControl - HIGH-PRESSURE FILTER, 530 BAR

103
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
9.2.10.3 HIGHPRESSURE FILTER, 530 BAR
1.
Flush the pump and high-pressure lter in accordance with
Chapter 5.17 and with pump's operating manual. Flush using the
gun so that the ushing agent ows through the lter cartridge (F).
Maximize the ow (remove the nozzle, open the dosing valve if
necessary).
Filter
identication
Mobilux® EP2 *
Anti-seize paste*
53MPa
530bar
7687psi
Filter installation position
Turned over
Loctite® 542 *
Loctite® 542 *
12
11
10
7
3
5
B_06836
1
21
2
2. Empty the pump in a controlled manner in accordance with
Chapter 5.17 and the pump's operating manual.
3. Place the grounded collection tank under the high-pressure lter.
4. Open ball valve (J).
5. Loosen union nut (A) with a size 70 wrench.
6. Unscrew the union nut (A) and lift slightly so that it does not get
dirty in the next step.
7. Remove the lter housing (B) with the union nut (A). The cone
spring (E) remains in the lter housing (B). If the O-ring (D) is not
damaged, it remains on the lter housing (B).
8. Remove the lter cartridge (F) and lter socket (G) from the lter
housing (B).
9. Clean all parts:
–Place the lter cartridge (F) and lter socket (G) in solvent.
Clean using brush.
–Fill the lter housing (B) approx. 1/3 full with solvent.
Close, wearing gloves, and shake well.
–Clean the distribution housing (H) using a brush.
10. If necessary, replace the O-ring (D) and/or lter cartridge (F).
For order no., see spare parts catalog.
11. Assemble all parts in reverse order. While doing so:
–Coat the thread of the distribution housing (H) with anti-seize
paste*.
–Coat O-ring (D) and pressure ring (C) with Mobilux® EP2 *.
–Observe the installation position of the lter cartridge (F):
Push the closed end with the lter identication ahead into
the lter housing (B).
–Make sure that the cone spring (E) is in the lter housing
(note the installation position). Press on the cone spring after
inserting the lter cartridge (F) and lter socket (G);
the spring action must be noticeable.
–Tighten the union nut (A) by hand.
12. Close ball valve (J).
13. Clean the spray gun's product lter in accordance with the spray
gun's operating manual.
14.
Fill pump in accordance with Chapter 5.17 and the pump's
operating manual.
* For order no., see spare parts catalog.