WAGNER TwinControl - FLUSHING PROGRAMS

75
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
7.6.2 FLUSHING PROGRAMS
Flushing program mode
The ushing steps can be dened in the mode shown under
parameters F1 to F20.
B
A
SET
TwinControl
B
B
A
A
B_02744
Enter ushing program
– Press [SET] during program step F1 (to F20). A appears on the left to enter the action.
Use [+] or [-] button to select the value. For input values, see description of action in
Table 2.
– Press [SET].
– Enter the amount using the [+] or [-] button.
– Press [SET].
– Enter the measuring unit cc (= ml) or sec using the [+] or [-] button.
– Press [SET] (the measuring unit displayed is saved).
– The [+] or [-] button takes you to the next program step (F2 or Fx).
Table 1: ushing steps
Step F Actions Quantity Unit
*
*
Table 2: actions
Action Description of action
0 No activity
1 Product A
2 Product B
3 Flushing A
4 Flushing B
5 Wait time
Table 3: repetitions
Step F Step Description
F31 ** 3-20 Start repetition
F32 ** 3-20 End repetition
F33 1-200 Number of repetitions
** F31 must be smaller than F32.
* With repeated ushing (2 instances of ushing one after another), ushing steps
"F1" and "F2" are only performed the rst time. During the second ushing cycle, the
ushing program starts from step "F3".