WAGNER TwinControl - TROUBLESHOOTING; Fault display

105
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
10 TROUBLESHOOTING
Fault display
If a fault occurs, it is indicated by the following:
The horn sounds and the system stops.
The alarm display lights up (control unit and remote control).
A fault is indicated on the display.
Acknowledge fault
With the [Stop] button.
Fault rectication
If the alarm signal sounds, it is advantageous to be able to determine which operating
situation has caused the error. Fault rectication can be carried out in accordance with the
list in Chapter 10.1.
Incorrect product in spray hose
After a fault, the spray hose is lled with incorrectly mixed product. This incorrect product
must be discharged or removed with intermediate ushing.
Defect in control unit
Faults caused by a defect in the control unit may only be remedied by a trained expert
(e.g., workshop electrician)!
WARNING
Electric shock hazard inside the control unit!
Danger to life from electric shock.
May only be installed/maintained by skilled electricians or under their supervision.
Operation according to the safety regulations, re protection and electrotechnical
rules.
Must be de-energized before work is commenced on active parts.