91
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
8.10.3 SPRAYING MODE
Safety precautions:
Before spraying mode with electrostatic system can be started, it must be checked whether
product, that can be sprayed (without solvent), is coming out of the gun nozzle.
1. Press and release the trigger of the spray gun and check that product, that can be
sprayed (without solvent), is coming out of the gun nozzle. Perform the paint lling
procedure, if necessary, and set the correct lling quantity.
2. Switch on the electrostatic system on the VM 5000 control unit manually as described
in the VM 5000 operating manual.
3. Perform spraying mode as described in this operating manual (TwinControl).
Ensure that the electrostatic system has been set correctly on the GM 5000 spray gun
as described in the GM 5000 and VM 5000 operating instructions.
8.10.4 WORK INTERRUPTION STOP
1. Switch o the electrostatic system on the VM 5000 control unit manually as described
in the VM 5000 operating manual.
2.
Relieve pressure according to Chapter 8.9.
8.10.5 FLUSHING
Safety precautions
Before the TwinControl system is ushed, the electrostatic system on the VM 5000 control
unit must be switched o manually. This ensures that under no circumstances will solvent
be sprayed if the electrostatic system is switched on. The electrostatic system can cause
ignitable solvent-air mixtures to explode.
1. Switch o the electrostatic system on the VM 5000 control unit manually as described
in the VM 5000 operating manual.
2. Briey press and release the trigger of the GM 5000 spray gun and check that the
electrostatic system has been switched o.
3.
Carry out ushing in accordance with Chapter 8.8. The "Flushing" illuminated display
lights up during ushing.
8.11 CONNECTION KIT FOR GUN FLUSH BOX OPTION
Software settings and tests
1. Attach the compressed air and increase slowly to the desired value. Switch on the
voltage supply. Watch out for compressed air leaks!
2.
Set parameter P114 in accordance with Chapter 7.6 (GFB = 1, yes).
For system parameters, see Chapter 5.10.
3. Insert a gun into the gun ush box and lock the cover.
4.
The trigger mechanism of the gun ush box may not be operated now, i.e., is
depressurized at connection no. 3 and at no. 3- is pressurized (see Chapter 5.8 and 5.9).
5. Press the "ushing" button or allow the TwinControl to undercut the pot life. As soon
as the pot life alarm is triggered, electro-pneumatic valve no. 3 is actuated. The trigger
mechanism of the gun ush box is now operated, i.e., is pressurized at connection no. 3
and is depressurized at no. 3-.
To Next Page
Loading...
