WAGNER TwinControl - CLEANING OR REPLACING THE PRODUCT FILTER; ANGLED INLINE FILTER (530 BAR); STRAIGHT INLINE FILTER (270 BAR)

102
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
9.2.10 CLEANING OR REPLACING THE PRODUCT FILTER
9.2.10.1 ANGLED INLINE FILTER 530 BAR
1.
Flush the pump and inline lter in accordance with Chapter 5.17 with pump's operating manual.
Flush using the gun so that the ushing agent ows through the inline lter. Maximize the ow
(remove the nozzle, open the dosing valve if necessary).
2.
Empty the pump in a controlled manner in accordance with Chapter 5.17 and the pump's operating
manual.
3. Place the grounded collection tank under the inline
lter.
Flow direction
* For order no., see spare parts catalog.
53MPa
530bar
7687psi
B_07113
C*
B
D
E
A*
E
F*
4. Unscrew the lter by turning the handle (D).
5. Remove the lter insert (C).
6. If the inline lter has any leaks: Replace the seal (A).
7. Insert the new lter insert (C). Note the installation
position: closed end in direction of ow.
8. If necessary, coat the thread with anti-seize paste (F).
9. Assemble the turning handle (D), inlet housing (B)
and outlet housing (E) and tighten by turning the
handle.
10. Clean the spray gun's product lter in accordance
with the spray gun's operating manual.
11.
Fill pump in accordance with Chapter 5.17 and the
pump's operating manual.
9.2.10.2 STRAIGHT INLINE FILTER 270 BAR
1.
Flush the pump and inline lter in accordance with Chapter 5.17 and with pump's operating manual.
Flush using the gun so that the ushing agent ows through the inline lter. Maximize the ow
(remove the nozzle, open the dosing valve if necessary).
2.
Empty the pump in a controlled manner in accordance with Chapter 5.17 and the pump's operating
manual.
3. Place the grounded collection tank under the inline lter.
27MPa
270bar
3916psi
* For order no., see spare parts catalog.
Flow direction
B_05274
2
3
5
1
**
4. Unscrew the inlet housing (B) and outlet housing(E) with two
size 19 wrenches.
5. Remove the lter insert (C).
6. If the inline lter has any leaks: Replace the seal (A).
7. Insert the new lter insert (C). Note the installation position:
closed end in direction of ow.
8. If necessary, coat the thread with anti-seize paste (F).
9. Screw together the inlet housing (B) and outlet housing (E)
with two size 19 wrenches.
10. Clean the spray gun's product lter in accordance with the
spray gun's operating manual.
11.
Fill pump in accordance with Chapter 5.17 and the pump's
operating manual.