61
VERSION 10/2018 ORDER NUMBER DOC 2339321
.
7.10. Relieve pressure of A-product-circuit:
– Relieve air pressure in accordance with the operating manual for pump A.
– Slowly open the return valve of pump A. When no further overpressure is
detected, close the return valve again.
– Point the spray gun into the grounded metal tank for return product.
– Release and open spray gun to relieve the pressure. Avoid splashback.
– When no further overpressure is detected, close and secure the spray gun.
7.11. Close product valve by pressing [Stop].
8. Filling pump B:
8.1. Open return valve of pump B. As soon as pure working product comes out,
close return valve again.
8.2. Select component "B" in sub-menu
B
and press [Start].
8.3. Point the spray gun (preferably without nozzle) into the grounded metal tank.
Release the spray gun safety and open carefully. Flush until the hose content
is emptied and pure working product, without air inclusions, comes out. Close
and secure the spray gun.
8.4. Relieve pressure of B-product circuit:
– Relieve air pressure in accordance with the operating manual for pump B.
– Slowly open the return valve of pump B. When no further overpressure is
detected, close the return valve again.
– Point the spray gun into the grounded metal tank for return product.
– Release and open spray gun to relieve the pressure. Avoid splashback.
– When no further overpressure is detected, close and secure the spray gun.
8.5. Close product valve by pressing [Stop].
9. Dispose of the contents of the waste tanks according to the local regulations.
10.
The system is ready to start. Continue with calibration (Chapter 6.6.4) or spraying
(Chapter8.7). If not continuing with work straight away, ush the system (Chapter 8.8).
To Next Page
Loading...
