WAGO 750 Series System Manual

Serie 750, 753 Planning
System manual | Version: 3.0.2 41
• I/O module: 1W
4.6.2 I/O Test
With the WAGO I/O System, it is possible to test your wiring simply and effectively using
an I/O test.
For example, WAGO software solutions such as e!COCKPIT and WAGO-I/O-CHECK
make it possible to:
• Switch inputs and outputs
• Display digital input states
• Display analog input values
• Output analog values
Detailed instructions are available in the & product manual for e!COCKPIT and WAGO-I/
O-CHECK.

WAGO 750 Series Specifications

General

Protection Class	IP20
Bus Couplers	PROFIBUS, CANopen, Ethernet
Modules	Digital Input, Digital Output, Analog Input, Analog Output
Mounting	DIN rail mounting
Voltage Supply	24 V DC (typical)
Communication Protocol	Depends on the bus coupler (e.g., PROFIBUS, CANopen, DeviceNet, Ethernet)
Digital Input Channels	Varies by module (e.g., 8, 16 channels)
Digital Output Channels	Varies by module (e.g., 8, 16 channels)
Analog Input Channels	Varies by module (e.g., 2, 4, 8 channels)
Analog Output Channels	1, 2, 4 channels (depending on module)
Width	12 mm, 24 mm (typical module widths)
Number of Channels	Varies by module type
Current Consumption per Channel	Varies by module type