Safety
WP1624
Firewood Processor
Safety
19
12. Warning!
Risk of serious injury or death if the engine is
not shut off during maintenance procedures.
Shut off the engine and remove the key.
13. Warning!
Risk of explosion.
Do not refuel the machine while smoking or near
open flame or sparks. Serious injury can result.
14. Warning!
Z94222
Risk of burns to exposed skin from hot
surfaces.
Stay clear of hot exhaust system.
15. Warning!
Charging a frozen battery can cause it to
explode.
Warm the battery to 60 °F (16 °C) before
charging.
16. Warning!
Risk of injury from falling off equipment.
Do not climb or step on conveyor.
17. Warning!
Risk of injury from objects falling off
conveyor.
Do not walk under or stand under the
conveyor.
IMPORTANT! If parts are replaced that have safety signs on
them, new signs must be applied. Safety signs must always
be replaced if they become damaged, are removed, or
become illegible.
Safety signs are included in the product decal kit available from
your authorized dealer. Decals are not available separately.
2.11 Replacing Damaged Safety Signs
• Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or the factory.
• Keep safety signs clean and legible at all times.
• Parts replaced that had a safety decal on them must also
have the safety sign replaced.
Procedure
Installation area must be clean and dry. Make sure the surface is
free of grease or oil. Ambient temperature must be above 50 °F
(10 °C).
Determine exact position before removing the
backing paper on the decal.
1. Peel the decal off the backing sheet.
2. Align the decal with an edge on the machine if possible.
3. Starting on one edge, carefully press the center of the
exposed sticky backing in place, smoothing it out as you
work from one side to the other.
4. Use a squeegee, credit card or similar to smooth it out.
Work from one end of the decal to the other end.
Small air pockets can be pierced with a pin and smoothed out
using the piece of sign backing paper.
To Next Page
Loading...
