WP1624
Firewood Processor
Machine Set-up
33
5.7 Saw Shield
• Adjust the position of the saw chain shield as required.
• Replace the impact-resistant glazing if any scratches or
other damage cause glare from the sun or obstruct the
operator's view.
01050
Fig. 35 – Saw Shield
5.8 Integrated Conveyor
(If equipped)
5.8.1 Conveyor Height, Changing
Conveyor height is adjusted using the hand winch on the
left-hand side. An internal brake holds the winch at the desired
height.
To raise the conveyor:
• Turn winch handle clockwise. (The winch ratchet clicks as
the handle is turned.)
To Lower the Conveyor:
• Turn the handle counter-clockwise. (There is no clicking
sound when lowering.)
• When the conveyor is at the desired height, turn the winch
handle back in the clockwise direction to engage the brake
until two clicks are heard.
00386
Fig. 36 – Conveyor Hand Winch
5.8.2 Conveyor Angle, Changing
1. Remove snap lock pin and push conveyor to right or left to
the desired angle.
2. Reinsert snap lock pin.
00385
Fig. 37 – Changing Conveyor Angle
To Next Page
Loading...
