WP1624
Firewood Processor
Operating Instructions
51
7.12 Storage
Placing Wood Processor in Storage
After the season's use or when the machine will not be used
for a period of time, completely inspect all major systems of
the wood processor. Replace or repair any worn or damaged
components to prevent any unnecessary down time at the
beginning of the next season.
IMPORTANT! For information on engine storage, refer to
the engine manufacturer's manual in the manual storage
tube.
Procedure
1. Clear out all wood material from the machine.
2. If storing for more than 1 month, add stabilizer to the fuel
system. Run the engine for a few minutes to allow the
stabilized fuel to cycle through. Refer to the engine manual
for further information on engine storage.
3. Thoroughly wash the machine to remove all dirt, mud, and
debris.
4. Inspect all moving parts and remove any entangled
material.
5. Fold up the live deck.
6. Block or chock the wheels.
7. Cover the machine with a waterproof tarp, if storing it inside
is not possible.
Removing from Storage
When removing this machine from storage, follow the
Pre-operation checks. See page 34.
To Next Page
Loading...
