WP1624
Firewood Processor
Operating Instructions
43
00410
Fig. 57 – Bar Nuts
3. Turn adjusting screw counter-clockwise to loosen chain.
01060
Fig. 58 – Adjusting Screw
7.7 Bar Oil Flow Rate, Adjusting
Adjust bar oil flow rate by opening or closing the flow control
valve on the side of the bar oil reservoir. Ambient temperatures
affect oil flow rate. Adjust as required.
Bar oil should be visible coming off the end of the saw chain
during operation.
Fig. 59 – Bar Oil
• Turn the knob out counter-clockwise to increase oil flow to
the saw.
• Turn it in clockwise to decrease the oil flow rate.
01053
Fig. 60 – Bar Oil Flow Control
Biodegradable bar oil is recommended. Reservoir
capacity is 6 US qt (5.6 L).
To Next Page
Loading...
