WP1624
Firewood Processor
Troubleshooting Guide
65
Problem Cause Solution
Log falls lengthwise into splitting chamber
too often.
Dull chain is finishing the cut too slowly. Sharpen or replace chain.
Log dropper set too light. Set one or both gas struts to active on the log dropper.
Log dropper not centered under block.
Move log dropper to halfway point between saw and log length
indicator.
Wedge adjust cylinder does not lower.
Wood left under wedge prevents it from moving
down.
Clear wood away from under wedge.
Engine related issues. Refer to your engine instruction manual for specific trouble shooting instructions / requirements.
To Next Page
Loading...
