Safety Precautions
Disconnect the power supply
The product should be placed close to or easily accessible to power sockets, so as to allow easy disconnection of power supply!
Laser Safety
The laser radiation is harmful to the human body. Since laser components are completely sealed in the printer, laser radiation will
not leak. To avoid laser radiation, please do not randomly disassemble the printer!
The printer follows the provisions of Class 1 laser products under CFR standard. The printer has a Class III b laser diode, which
has no laser radiation leakage among laser components.
The laser components shall complies with the requirements of: U.S. Code of Federal Regulations, 21 CFR 1040, IEC 60825-1
The following label is attached to the laser components inside the printer:
Reclamation and recycling
To protect the environment, our corporation has already established the system of reclamation and recycling for waste products.
Please refer to the Printon official website for product recovery at www.waltonbd.com.
Safety Warning
Please note the following safety warnings before using the printer:
There is high-voltage electrode inside the printer. Before cleaning
the printer, make sure the power is turned off!
The fuser unit is hot when and after printing. Touching the fuser
unit (the shaded area as shown) may cause burns!
The fuser unit is attached with a high temperature warning label.
Please do not remove or damage this label.
To Next Page
Loading...