5.1.3. How to disable the Wi-Fi network connected
Connect the wireless network in infrastructure mode by the steps above. If connected, the Wi-Fi light on the control panel is
normally on. Press and hold this button for more than 2s to disconnect from Wi-Fi network (Wi-Fi light will be off).
5.2. Wi-Fi hotspot mode
You can establish a connection between a wireless network-enabled computer and a wireless network-enabled printer without
using an access point (wireless route).
5.2.1. Preliminary preparations
1. Printer with Wi-Fi hotspot function.
2. Computer with wireless network function.
5.2.2. Wi-Fi Hot Connection
Before connecting the printer hotspot, enable the Wi-Fi hotspot function of the printer by tapping the "Wi-Fi" button on the
printer panel.
5.2.3. Wi-Fi Hotspot Configuration
When the wireless hotspot of printer is active, the user can connect to it directly by searching. The wireless hotspot is enabled by
default, and the default password is “12345678”. The printer-specific SSID and password can be obtained from Wi-Fi
Configuration Information Page, which can be printed out by selecting Print Wi-Fi Configuration. After establishing the
connection, the configuration can be completed according to the Web configuration method.
5.3. Wireless network setup FAQs
1. The printer is not found.
• If the power of computer, access point (wireless router) or printer is turned on.
• If the computer is connected to printer with USB cable.
• If the printer supports wireless network connection.
2. SSID cannot be found when network is connected
• Inspect if the power switch of access point (wireless router) is turned on.
• The printer cannot find the SSID of the access point (wireless router) you need to connect, please check the SSID of
access point and try to connect again.
• Every time when the setup of access point (wireless router) is changed, you must set up the wireless network of printer
again.
To Next Page
Loading...