16. If you continuously print multiple pages, the surface of the tray will become very hot. Take care not to touch this surface, and
keep children away from this surface;
17. The signal wire of the device connected with the printer cannot be connected to the outdoors;
18. Please ensure timely ventilation in case of a prolonged use or printing huge amounts of documents in a poorly ventilated
room;
19. In standby status, the product will automatically enter into the power saving (sleep) mode if it does not receive any job order
for a while (such as 1 minute); and it can realize zero power consumption only if it has not been connected with any external input
power supply;
20. As the Class 1 equipment, the product must be connected to the power supply outlet with protective grounding line when
using;
21. This product should be placed according to the shipping marks on the product package box during delivery;
22. This product is a kind of low-voltage equipment. When using this product below the specified voltage range, please refer to
the product precautions or call Printon Aftersales Service Centre, if the toner comes off the printed contents, or the equipment
starts slowly;
23. This product is sold as a complete machine. The consumers can go to Printon Aftersales Service Centre to purchase parts
they need. If the product sold is inconsistent with the package list, please go to the specified Aftersales Service Centre to solve
the problem;
24. Install this product in a place with the temperature between 10°C and 32.5°C and the relative humidity between 20% and
80%;
25. For security and other reasons the printer may switch to intermittent printing after a certain amount of continuous printing.
26. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
27. IC Radiation Exposure Statement:
This equipment complies with Canada and FCC radiation exposure limits set forth for uncontrolled environments. This equipment
should be installed and operated with a minimum distance of 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
28. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
To Next Page
Loading...